GTA 6 Drawbridge Jump Challenge: Peregrine Bay and Three 100-Foot Jumps

GTA 6 Drawbridge Jump Challenge
GTA 6 Drawbridge Jump Challenge

The GTA 6 Drawbridge Jump Challenge is a three-jump stunt at the drawbridge in Peregrine Bay. Each jump has to cover more than 100 feet, and you need to complete all three without leaving your vehicle. You can use a fast road car. There is no named car or compulsory upgrade in the challenge description.

The bridge has a control booth, which sounds handy until you notice the no-exiting rule. Leaving your car to raise it between attempts can spoil the sequence. Here’s where the bridge is and how to plan a run that doesn’t depend on getting out halfway through.

GTA 6 Drawbridge Jump Challenge location in Peregrine Bay

Find Peregrine Bay on the map and zoom in on the short road drawbridge crossing a narrow inlet. The bridge runs diagonally off a curving coastal road, with a small access road alongside it. Look for the nearby tunnel building, not a separate stunt-jump icon.

Drive around the crossing once at normal speed. Check which road gives you the longest straight approach to the raised deck and where you can turn around after landing. The GTA 6 Drawbridge Jump Challenge is about covering the jump distance three times, so the space before the ramp matters as much as the ramp itself.

How to raise the bridge without losing the run

GTA 6 Drawbridge Jump Challenge
A raised drawbridge in official Rockstar Games Vice City artwork. This is illustrative; the challenge itself is in Peregrine Bay.

The nearby control room has a Control Bridge prompt. If the deck is down when you arrive, you can raise it before beginning the three-jump run. Once you’ve started, stay in the same car and wait for the bridge to open between attempts. Going back into the control room, switching cars or repairing at a shop would break the uninterrupted vehicle condition.

Make three jumps over 100 feet

Pick a quick car that handles predictably and can take a landing. When the deck is raised, line up well back from the bridge and accelerate in a straight line. Drive off the raised section and aim for a clear landing. Merely crossing the gap is not enough. The game wants more than 100 feet of jump distance on each attempt.

Keep the car after the first jump. Turn around using the surrounding road, wait for the bridge to rise again, then make a second qualifying jump. Repeat once more. The GTA 6 Drawbridge Jump Challenge requires three separate jumps made without getting out of that vehicle. Swapping into a faster car halfway through is not a safe way to finish the sequence.

GTA 6 Drawbridge Jump Challenge
GTA 6 Drawbridge Jump Challenge

GTA 6 Drawbridge Jump Challenge not completing? Check these details

First, make sure you used the raised drawbridge, rather than a nearby ordinary stunt jump. Second, check that each leap travelled more than 100 feet, not exactly 100. Third, think back over the attempt: did you climb out to use the bridge controls, repair the car or swap vehicles? That breaks the condition printed on the challenge card.

You can find the GTA 6 Drawbridge Jump Challenge under Progress > Challenges > Vehicle. Look for its Completed checkmark after your third jump. The game’s tracker is better evidence than a dramatic landing animation. If your car gets damaged so badly you must abandon it, begin a fresh three-jump sequence rather than trying to carry earlier progress into a different vehicle.

Does Drawbridge Jump count towards 100%?

There are 80 challenges in GTA 6, but the 100% checklist requires any 70. You can leave the GTA 6 Drawbridge Jump Challenge unfinished if you would rather complete an easier challenge in another category. If you want to finish all ten Vehicle challenges, the Peregrine Bay stunt will eventually need to be done.

Related GTA 6 Guides

Official image source: Rockstar Games, Grand Theft Auto VI screenshots.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *